K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Power Window Switch: Service and Repair
Power Window Switch Replacement
REMOVAL PROCEDURE
1. Remove the power accessory switch panel.
2. Disconnect the power window switch electrical connector.
3. Remove the screws from the window switch.
4. Remove the switch from the switch panel by lifting the rear of the switch and sliding the switch out from the switch panel.
INSTALLATION PROCEDURE
1. Install the switch to the switch panel sliding the front tabs in first. Rock the switch down in order to seat the switch completely.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the screws to the window switch.
Tighten
Tighten the window switch screws to 2 N.m (18 lb in).
3. Connect the electrical connector to the window switch.
4. Install the power accessory switch panel.
