K Yukon/Denali 4WD V8-5.7L VIN R (2000)
^
Tighten the TORX(R) screws to 9 Nm (80 lb in).
^
Tighten the hex head screws to 2 Nm (18 lb in).
^
Position the courtesy lamp and install the retaining screw.
Tighten
Tighten the socket retaining screw to 1.4 Nm (12 lb in).
58.
Install the sound insulator panel, if equipped.
59.
Install the knee bolster trim panel.
60.
Install the IP trim plate bezel to the IP.
61.
Connect the negative battery cable.
62.
Observe the Security indicator lamp when the key is turned to the RUN position. The Security lamp should be Off. If the lamp is On, you must
recheck your work.
63.
Observe the SIR lamp. The lamp should be Off.
64.
Remove the fender covers and close the hood.
65.
Remove the seat covers.
Warranty Information
For vehicles repaired under warranty, use table as shown.
DISCLAIMER
