K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Rear Door Latch Control Replacement
Removal Procedure
1. Remove the trim panel, as necessary.
2. Remove the water deflector, as necessary.
3. Remove the access hole cover, as necessary.
4. Disconnect the lower latch control rod (2) from the control handle clip.
5. Disconnect the upper latch control rod (1) from the control handle clip.
6. Remove the latch control handle nuts.
7. Remove the latch control handle.
Installation Procedure
1. Install the latch control handle.
2. Install the latch control handle nuts.