K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Trunk / Liftgate Shock / Support: Service and Repair
Window Support Replacement - Endgate
Window Support Replacement - Endgate
Removal Procedure
Caution: Do not attempt to remove or loosen gas support assembly attachments with glass in any position other than fully open as
personal injury may result.
Important: Do not intermix the original quality gas supports with other quality supports since not all of the supports have the same
output level.
1. Replace in pairs.
2. Remove the window defogger wires attached to the gas supports (2), if equipped.
3. Remove the ball sockets (4) from the glass side.
*
Support the rear window glass.
*
Carefully pry the gas support ball socket from the ball.
*
Insert a small prying device between the ball and the ball socket.
Pull the gas support from the window.
4. Remove the ball sockets (3) from the body side.
Installation Procedure
1. Install the gas support ball socket to the body (3) and the glass (4) sides.
2. Push the ball socket onto the ball.
3. Install the rear window defogger wires to the gas supports (2), if equipped.