K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Body / Frame Mount Bushing: Service and Repair
Body Mount Replacement (Extended Cab)
Body Mount Replacement (Extended Cab)
Removal Procedure
Properly support the frame while changing the cab mounts. Lower the side where the mount is placed in order to provide clearance for the mount when
changing only 1 mount.
1. Raise the vehicle on the hoist. Refer to Vehicle Lifting.
2. Place the jack stands under the cab on the side of the vehicle where the mounts are positioned.
3. Loosen the mounting bolts on the side where the mounts are positioned.
4. Remove the mounting bolt (3).
5. Remove the lower cushion retainer (4).
6. Remove the lower cushion (5).
7. Lower the hoist and support the cab with the vehicle jacks.
8. Remove the upper cushion (6).
Installation Procedure
1. Install the upper cushion (6).
2. Raise the frame on the hoist.
3. Install the lower cushion (5).
4. Install the lower cushion retainer (4).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the mounting bolt (3), and remove the jacks.
Tighten the mounting bolts to 75 N.m (55 lb ft).
6. Lower the hoist.
