K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Remove the seat retaining bolts (13).
2. Remove the right and left seat belt bolts from the floor.
3. Pull the seat belts through the seat.
4. Remove the seat from the vehicle.
5. Remove the bolts (6) and seat riser (7) from the seat.
6. Remove the push pins and rods from the seat material and frame.
7. Release the springs from the bottom of the seat adjuster.
8. Remove the bolts and trim from the sides of the seat.
9. Remove the seat back frame from the seat frame.
10. Remove the seat cover (17) from the seat.
11. Remove the foam pad (15) from the seat.
Installation Procedure
1. Install the foam pad (15) to the seat.
2. Install the seat cover (17) to the seat.
3. Install the seat back frame to the seat frame.
4. Install the bolts and trim to the sides of the seat.
5. Install the springs to the bottom of the seat adjuster.
6. Install the push pins and rods to the seat material and frame.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the bolts (6) and seat riser (7) to the seat.
Tighten the bolts to 55 N.m (41 lb ft).
