K Yukon/Denali 4WD V8-5.7L VIN R (2000)
5. Install the piston inside J 24548.
6. Install the piston halfway into the bore.
7. Remove J 24548. Make sure that the boot is sitting firmly in the groove.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the bleeder valve.
^
Tighten the bleeder valve to 13 Nm (110 inch lbs.).
Front
Removal Procedure
^
Tools Required
-
J 24548 Disc Brake Piston Ring Compressor
-
J 36474 75 mm Boot Seal Installer or
-
J 36475 80 mm Boot Seal Installer or
-
J 38453 86 mm Boot Seal Installer