K Yukon/Denali 4WD V8-5.7L VIN R (2000)
5. Remove the mounting fasteners.
6. Remove the inflatable restraint front end discriminating sensor from the vehicle.
IMPORTANT: The following procedures should be utilized in the event that sensor mounting holes or fasteners are damaged to the extent that the
sensor may no longer be properly mounted.
7. Use the following procedure to repair fasteners:
7.1.
Remove and discard the fastener.
7.2.
Chisel off the damaged weld nut.
7.3.
Condition the front end lower tie surface where the new weld nut is to be installed.
7.4.
Install the new weld nut (IP/N 11514034) or equivalent into position.
7.5.
Migweld the new weld nut to the front end lower tie surface in the correct location.
7.6.
Use the new fastener (IP/N 11515926) or equivalent.
INSTALLATION PROCEDURE
1. Install the inflatable restraint front end discriminating sensor to the front end lower tie surface and ensure that the arrow is pointing toward the
front of the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the inflatable restraint front end discriminating sensor mounting fasteners.
Tighten
Tighten fasteners to 8 N.m (71 lb in).