K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Manifold Absolute Pressure (MAP) Sensor: Description and Operation
Manifold Absolute Pressure (MAP) Sensor
The Manifold Absolute Pressure (MAP) sensor responds to any changes in the intake manifold pressure. The pressure changes as a result of the engine
load and speed. The MAP sensor converts this to a voltage output.
A closed throttle on the engine coast down would produce a relatively low MAP output voltage. A Wide Open Throttle (WOT) would produce a high
MAP output voltage. This high output voltage is produced because the pressure inside of the manifold is the same as outside the manifold. The MAP is
inversely proportional to what is measured on a vacuum gauge. The MAP sensor is used for the following:
^
Altitude determination
^
Ignition timing control
^
Exhaust Gas Recirculation (EGR) diagnostic
^
Speed density fuel management default
When the VCM detects a malfunction in the MAP sensor circuit, the following DTCs will set:
^
DTC P0106 Circuit Performance Malfunction
^
DTC P0107 Circuit Low
^
DTC P0108 Circuit High
^
DTC P1106 Intermittent Circuit High
^
DTC P1107 Intermittent Circuit Low
