K Yukon/Denali 4WD V8-5.7L VIN R (2000)
1. Install the propeller shaft into the transmission.
2. Ensure that the slip joint splines are lubricated.
3. Bottom the propeller shaft yoke in the transmission.
4. Install the center bearing support.
5. Align the center bearing support 90 degrees to the propeller shaft center lines.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the center bearing support bolts.
Tighten the center bearing support bolts to 35 Nm (26 ft. lbs.).
7. Install the slip yoke (4) by aligning the missing tooth (5) with the bridged tooth (6) on the splined shaft (1).
8. Support the propeller shaft.
9. Ensure the slip yoke ears are horizontal.
10. Align the reference marks and install the propeller shaft to the rear differential yoke.
11. Install the retainers.
12. Install the bolts.
Tighten the bolts to 20 Nm (15 ft. lbs.).
13. Inspect for proper joint fit.
