K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the four bolts securing the transfer case shift control to the floor panel bracket.
Tighten the transfer case control bolts to 11 Nm (97 inch lbs.).
2. Install the shift lever end to the transfer case linkage rod.
Lower the vehicle.
3. Install the wiring harness to the transfer case shift control bezel.
4. Install the four screws securing the transfer case shift control bezel to the floor panel bracket and the shift bracket.
Use the locator pin on the transfer case shift control bezel in order to aid in positioning the bezel onto the brackets.
Tighten the transfer case shift control bezel screws to 2 Nm (18 inch lbs.).