K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
7.1.
Align the mark (2) on the weatherstrip to align with the center of the LH striker bolt hole (1).
7.2.
Push the weatherstrip onto the flange working outward in both directions (3). Ensure that the weatherstrip is secure in both corners.
7.3.
Push the weatherstrip down both sides of the outer flanges to the lower corners (4).
7.4.
Install the weatherstrip to the center of the lower door opening flange (5).
7.5.
Push the excess loops of the weatherstrip from the center, outward to corners (6).
7.6.
Push the weatherstrip securely around the perimeter of the door opening flange.
8.
Install the rear upper body opening molding.
9.
Install the RH and the LH rear corner lower garnish moldings and rear sill trim as an assembly.
10.
Install the RH and the LH rear corner upper garnish moldings.
11.
Install the spare tire. Refer to the Tires and Wheels subsection of the Service Manual.
Weatherstrip Replacement (Endgate Models)
Use the following steps to install the endgate door opening primary weatherstrip:
1.
Remove the rear floor rear trim plate.
2.
Remove the LH and the RH rear corner upper garnish moldings.
3.
Remove the LH and the RH rear corner lower garnish moldings.