K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
Engine Accessory Bracket: Service and Repair
Accessory Brackets Replacement (Right Side)
REMOVAL PROCEDURE
1. Disconnect both the battery negative cables from the batteries. Refer to Battery Cable in Powertrain Management.
2. Remove the upper fan shroud from the radiator. Refer to Fan Shroud Replacement (Upper) in Cooling System.
3. Remove the drive belt from the drive pulleys. Refer to Drive Belt Replacement.
4. Remove the generator from the accessory bracket. Refer to Generator Replacement (CS 130D) in Starting and Charging.
5. Remove the drive belt tensioner from the accessory bracket. Refer to Drive Belt Tensioner Replacement.
6. Remove the vacuum pump from the accessory bracket. Refer to Vacuum Pump Replacement.
7. Remove the accessory bracket bolts from the engine block.
8. Remove the accessory bracket from the vehicle.
INSTALLATION PROCEDURE
1. Install the accessory bracket to the vehicle.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the accessory bracket bolts to the engine block.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
^
Tighten the nuts to 50 Nm (37 ft. lbs.).
3. Install the drive belt tensioner to the accessory bracket. Refer to Drive Belt Tensioner Replacement
4. Install the vacuum pump to the accessory bracket. Refer to Vacuum Pump Replacement.
5. Install the generator to the accessory bracket. Refer to Generator Replacement (CS 130D) in Starting and Charging.
6. Install the drive belt on the drive pulleys. Refer to Drive Belt Replacement.
7. Install the upper fan shroud to the radiator. Refer to Fan Shroud Replacement (Upper) in Cooling System.
8. Connect both the battery negative cables to the batteries. Refer to Battery Cable in Powertrain Management.