K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
20.
From the technicians point of view, the FRONT of the sensor will have:
^
A flush rotor flange cuff (3)
^
A pin hole (1) for the centering pin (note location of the pin hole)
^
An alignment mark (2) on the flush rotor flange cuff (3) for installation
21.
Remove the connector from the sensor.
22.
Remove the sensor from the adapter and bearing assembly.
23.
To install the sensor, proceed to step 17 in the installation section.
24.
From the technicians point of view, the FRONT of the sensor will have:
^
A flush rotor flange cuff (4)
^
A pin hole (2) for the centering pin (note location of the pin hole)
^
An alignment mark (3) on the flush rotor flange cuff (4) for installation
^
A foam ring (1)
25.
Remove the connector from the sensor.
26.
Remove the sensor from the adapter and bearing assembly.
27.
To install the sensor, proceed to step 21 in the installation section.
Installation Procedure
Important:
If reusing the existing sensor, no centering of the sensor is required.
1.
If installing a new sensor, it will come with a pin installed in the sensor. Do not remove the pin until the sensor is seated.