K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
Important: Do not hammer the pinion flange onto the pinion stem.
4. Install the pinion flange using the J 8614-O1.
5. Use the alignment marks (1) in the installation of the pinion flange (2).
6. Install a washer and a new nut.
^
Tighten the nut on the pinion stem as close as possible to the alignment marks without going past the mark.
Notice: Refer to Fastener Notice in Service Precautions.
^
Use the record of the alignment marks and the thread count as a reference.
^
Tighten the nut a little at a time and turn the pinion flange several times after each tightening in order to set the rollers.
Important: If the preload torque value recorded earlier was less than 3 inch lbs., reset the torque specification to 3-5 inch lbs.
7. Measure the torque required to rotate the pinion using the J 5853-B.
8. Compare the measurement of the torque with the measurement made during the removal procedure.
9. Continue tightening and measuring a little at a time until the preload is achieved.
10. Install the propeller shaft.
11. Install the retainers and bolts.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
12. Install the rear wheels and brake drums.
13. Lubricate the rear axle as necessary.
Pinion Oil Seal Replacement (10 1/2 Inch Ring Gear)
Removal Procedure
^
Tools Required
-
J 8614-01 Companion Flange Holder/Remover
-
J 24384 Pinion Oil Seal Installer
-
J 5853-B Torque Wrench
