R 3500 P/U 2WD V8-350 5.7L (1989)
Bearing Installation
1. Pulley rotor on J 21352-A and J 29886.
NOTICE: Do not support the rotor by resting the pulley rim on a flat surface during bearing installation since the rotor face will bend.
Staking The Pulley Bearing In The Pulley Bore
2. Bearing into the hub bore using J 9481-A and J 29886.
NOTICE: The stake metal should not contact the outer race of the bearing to prevent the possibility of distorting the outer race.
3. Stake the bearing using J 33019 at 120 degress intervals.
^
Rotate the assembly on the tool to make sure the staking location is completley supported by the tool.
4. Compressor in J 25008-A and clamp it in a vise.