R 3500 P/U 2WD V8-454 7.4L VIN W 4-bbl (1988)
the body several turns, remove J 9480-B and check that the shaft key (36) is properly in place in the keyway.
^
Air gap between contact surfaces of the clutch plate and hub assembly (2) and the pulley (6) should be 0.56-1.34 mm (0.022-0.057-inch).
^
Remove J 9480-B.
Inspect
^
Position of the shaft (39) (even with or slightly above the clutch hub).
3. Shaft nut (1).
^
Use J 9396 to hold the clutch plate and hub assembly (2).
Tighten
^
Shaft nut (1) to 27 N.m (20 ft. lbs.) with J 9399.
^
Hand spin the pulley (6) to check for free rotation.
Pulley and Bearing Assembly