S15/T15 2WD Jimmy L4-151 2.5L (1985)
Push Rod: Technical Service Bulletins
Push Rod Cover - Revised Removal Procedure
NUMBER:
86-B-88
GROUP:
6-Gasoline Engine
DATE:
June, 1986
SUBJECT:
NEW PUSH ROD COVER REMOVAL PROCEDURE
MODELS:
1985 AND 1986 S/T TRUCKS AND M VANS EQUIPPED WITH THE LN8 2.5L ENGINE
A new procedure has been developed to remove the push rod cover from 2.5L L4 engines without damaging the cover using components that already
exist on the engine.
-Cover Removal, S/T Truck
Removal S/T Truck
To remove the cover, unscrew the four nuts from the cover attaching studs (see Figure No. 1), reverse two of the nuts so the washers face outward and
screw them back onto the inner two studs. Assemble the two remaining nuts to the same two inner studs with washers facing inward. Using a small
wrench on the inner nut, on each stud, jam the two nuts tightly together. Again using the small wrench, on the inner nut, unscrew the studs until the cover
breaks loose.