S15/T15 2WD Jimmy L4-151 2.5L (1985)
1.
New extension housing (610).
-
Apply a 3 mm (1/8-inch) diameter bead of RTV sealant on the sealing surface of the extension housing.
-
Lubricate the detent/guide plate with lithium grease and install the detent ball (662) in the 3-4 neutral position of the detent plate.
-
Place the offset lever (659) and detent spring (660) over the detent ball (662).
-
Slide the extension housing against the transmission case while guiding the offset lever (659) over the shift shaft.
2.
Extension to case bolts.
-
Apply sealer to threads of top 2 bolts.
-
Tighten bolts to 30 N-m (25 lbs.ft.).
3.
Offset lever roll pin (663).
4.
Speed sensor
5.
Transmission.
-
Refer to Section 7B of the appropriate S/T Service Manual for complete transmission installation procedure.
-
Refill transmission with fluid.
Figure 3 - Damper Assembly
6.
Damper to transmission as shown in Figure 3.
-
Be sure damper is installed facing in the proper direction.
-
Tighten bolts (2) to 45 N-m (35 lbs.ft.).
-
Tighten weight bolt (5) to 100 N-m (75 lbs.ft.).
SERVICE PARTS INFORMATION
Part Number
Description
15674891
Damper Kit, Driveline Vibration
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicle repaired under warranty use:
