S15/T15 2WD Jimmy L4-151 2.5L (1985)
![background image](/gmc/s15/t15_2wd_jimmy/l4-151_2.5l/Page-1683004.png)
Fig. 14 Connections to operate round wiper motor independent of vehicle wiring
INTERMITTENT OPERATION
1.
Check solder connections at wiper terminal board.
2.
Connect wiper to operate in ``LO'' speed, Fig. 14. Connect ammeter (range 0---30 amps) in feed wire circuit to wiper and observe current draw.
Allow motor to run until it becomes hot. Current draw should be 3.5---4.0 amps. If not within specifications, motor is defective.