S15/T15 2WD Jimmy V6-173 2.8L (1988)
Exhaust Manifold: Service and Repair
1.
Disconnect battery ground cable.
2.
Raise and support vehicle, then disconnect exhaust pipe.
3.
If removing left manifold, remove rear manifold bolts and nut, then lower vehicle. Disconnect air management hoses and wires, remove power
steering bracket, if equipped, and remove manifold.
4.
On 1987 models, if removing right manifold, lower vehicle, remove manifold attaching bolts, alternator bracket and air pump, disconnect air
management hose and remove manifold.
5.
On 1988-92 models, if removing right manifold, lower vehicle, remove diverter valve and heat shield, manifold attaching bolts, alternator bracket
and air pump, disconnect air management hose and remove manifold.
6.
On all models, reverse procedure to install. Clean mating surfaces on manifold and head, then install manifold in position and tighten
manifold bolts to specifications.
