S15/T15 2WD Jimmy V6-173 2.8L (1988)
FIGURE 2
2.
Cut the front heater inlet and outlet hoses approximately 3.5 inches from the cowl (see Figure 1).
^
It may be necessary to cut about one inch out of each hose to allow the water heater valve (4) to be inserted. The exact amount of hose will
depend on hose routing for different engine configurations.
3.
Insert the front heater water valve (4) in the hoses and install the hose clamps (2). Torque the clamps to 1.4 - 2.0 N-m (12 - 18 lbs. in.).
Important
If the wiring for the blower relay evidences any interference with the valve, add convoluted conduit to protect the wires and tie strap the wires as
necessary to avoid rubbing.
4.
Install plastic vacuum line on the water valve fitting and add a 3/32 rubber sleeve for cou pling (see Figure 1). Route vacuum line with the antenna
