S15/T15 2WD P/U V6-173 2.8L VIN B 2-bbl (1983)
![background image](/gmc/s15/t15_2wd_p/u/v6-173_2.8l_vin_b_2-bbl/Page-1405001.png)
Brake Master Cylinder: Tools and Equipment
BASIC SERVICE (Removal and Installation)
- Fender cover (servicing and bleeding a master-cylinder can be a messy process)
CAUTION: DOT 3 or 4 brake fluid is very corrosive to the vehicles finish and electrical connections.
- Drip pan.
- Complete set of combination wrenches or sockets.
- Bleeding device:
-
Pressure bleeder or
-
Vacuum bleeder or
-
One-man brake bleeder kit or
-
Length of clear plastic hose (3/16 inch ID) and a glass jar.
Brake Bleeding Setup
- Small ruler or depth gauge (for adjusting the pushrod)
- Brake adjusting tool (rear brake adjustment should be checked)
- Clean shop towels.
OPTIONAL
- Master Cylinder bleeding kit (contains plastic fittings and hoses used for bleeding master cylinders)
- Suction bulb (for removing brake fluid from reservoir)
IF MASTER-CYLINDER IS OVERHAULED
- Snap-ring pliers
- Small pry bar (for separating the reservoir from the cylinder)
- Cylinder hone (cast iron cylinders only)
- Feeler gauges (for checking piston to cylinder clearance).