S15/T15 4WD Jimmy V6-262 4.3L VIN W CPI (1993)
Ignition Control Module: Service and Repair
Typical Distributor Components
REMOVE OR DISCONNECT
NOTE It is not necessary to remove ignition distributor assembly from engine.
-
Distributor cap and rotor.
-
Connectors from module.
-
Two module attaching screws.
-
Lift module from housing and remove.
INSTALL OR CONNECT
NOTE: Do not wipe silicone grease from metal face of module or distributor base (where the module seats), when reinstalling the same module. If
new module is to be installed clean distributor module base and spread new silicone grease on base and metal face of ignition module. The
purpose of the silicone grease is to cool module.
-
Module onto housing.
-
Module attaching screws. Tighten to 2 Nm (18 lb.in.)
-
Connectors to module.
-
Rotor and cap.