S15/T15 4WD Jimmy V6-262 4.3L VIN Z (1992)
Distributor: Service and Repair
Distributor Shaft, Pole Piece & Pickup Coil
Typical Distributor Components
REMOVE/DISCONNECT
1. With distributor removed, disconnect wires at module terminals
2. Roll pin from drive gear by driving out with 1/8 inch diameter drift punch. Mark shaft and driven gear so they can be aligned for assembly.
3. Gear, shim and tanged washer from distributor shaft. Remove any burrs that may have been caused by removal of pin.
4. Distributor shaft from housing. Bushings in housing are not serviceable.
5. Remove retainer from inside pickup coil assembly.
6. Remove pickup coil assembly from housing.
INSTALL/CONNECT
1.
Install pickup coil.
^ Fit tab on the bottom of coil into anchor hole in housing.
2.
Connect pickup coil wiring connector to module.
^ Make sure locking tab is in place.
3.
Install shield onto coil.
4.
Install retainer onto shield.