S15/T15 4WD Jimmy V6-262 4.3L VIN Z (1992)
TURBO
1.
Remove air cleaner duct, upper fan shroud, serpentine belt, fan and pulley.
2.
Using power steering pump pulley remover tool No. J 25034-B, remove pulley.
3.
Ensure pilot bolt bottoms in pump shaft by turning nut to top of pilot bolt. Hold pilot bolt and turn nut counterclockwise.
4.
Raise and support vehicle.
5.
Remove left wheel assembly and wheelhouse panel.
6.
Remove attaching bolt from hose bracket. Allow fluid to drain into a suitable container, Fig. 23.
7.
Disconnect return and pressure hoses from power steering pump, then cap hoses.
8.
Remove attaching bolts from rear bracket at alternator.
9.
Lower vehicle.
10.
Remove pump and attaching nuts from rear bracket.
11.
Reverse procedure to install.
Disassembly
Fig. 1 Exploded View Of TC Series Power Steering Pump
Fig. 2 Clip and reservoir removal
