S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
2.
If the latch is misaligned and/or the endgate glass is not snug against the weatherstrip, remove the endgate inner trim panel and loosen the latch
assembly by adjusting the nuts located on the side of the latch assembly (Figure 1, Item 4). Adjust the location of the latch and tighten the
adjusting nuts to 8.5-11.0 N-m (6-8 lbs. ft.).
3.
Check the endgate window latch for proper operation. If necessary, repeat steps 1 and 2.
REPLACEMENT PROCEDURE If the latch assembly is properly adjusted and the condition still occurs, the latch assembly should be replaced by
performing the following steps:
1.
Disconnect the negative battery cable.