S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Paint: Technical Service Bulletins
Body - Exterior Panel Repairs
Number:
83-I-39
Section:
I
Date:
Feb., 1983
Subject:
COMPLETE/PARTIAL PANEL REPAIR OF HIGH SOLIDS ENAMEL (WITH LACQUER) - 1982-83 CHEVROLET CAMAROS - NORWOOD
PRODUCTION 1982 CHEVROLET CELEBRITY FREMONT PRODUCTION - 1982-83 "S" CHEVROLET TRUCKS MORAINE, SHREVEPORT
AND PONTIAC (GMC) PRODUCTION
TO:
ALL CHEVROLET DEALERS
The following procedures are recommended when repairing exterior panels on the above high solids enamel painted vehicles.
PROCEDURE - COMPLETE PANEL REPAIR
^
Thoroughly clean exterior of vehicle with detergent and water, followed by a recommended wax, grease and silicone remover.
^
Block sand with 400 grit paper.
^
Treat any bare metal with a suitable metal conditioner.
^
Apply primer surfacer as required.
^
Block sand primed areas with wet or dry 400 grit paper.
^
Mask off.
^
Blow off all dust and wipe repair areas with a tack rag.
^
Apply sealer per manufacturer's directions. The following products or equivalents may be used:
-
Rinshed Mason - Clear Adhesion # 811.
-
Ditzler Pigmented Sealer # DL-1970.
-
DuPont Clear Midcoat # 222-S.
-
Sherwin Williams - Intercoat Sealer # P1C 48.
-
Acme - Intercoat Sealer # 571.
-
Rogers - Intercoat Sealer # 4571.
-
Martin Senour - Intercoat Sealer # 3061.
^
Apply acrylic lacquer color until full hiding is achieved.
^
Allow to dry overnight and compound exterior surface, including fascias (flexible panels).
PROCEDURE - PARTIAL PANEL REPAIR
The success of a spot or partial panel repair of O.E.M. high solids enamel with lacquer depends largely upon thorough cleaning and preparing the surface
with clear sealer ahd the use of a blend coat after color application. The blend coat significantly reduces the possibility of scaling at the perimeter of the
repair upon compounding and final polishing.
^
Clean the surface well beyond the intended repair area with a suitable grease, silicone and wax remover.
If required, feather edge broken paint film and condition bare metal. Apply primer-surfacer in a sufficient number of coats and sand in the usual
manner. Blow off all dust and wipe repair area with tack rag.
Apply the clear adhesion sealer following manufacturer's recommendations for spraying viscosity, number of coats and drying time. Pigmented
sealer should not be used for partial repair. Apply sealer 3-4 inches beyond intended edge of color application. For recommended sealers, see
complete panel repair.
^
Apply acrylic lacquer topcoats for proper hiding and color match.
