S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Fig. 7 Installing boot to caliper
5. Position dust boot in caliper counterbore and install, Fig. 7. Check the boot installation to be sure the retaining ring molded into the boot is not
bent and that the boot is installed below the caliper face and evenly all around. If the boot is not fully installed, dirt and moisture may enter the
bore and cause corrosion.
6. Install the brake hose in the caliper using a new copper gasket.
7. Install pads and caliper assembly.
