S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Turn Signal Switch: Service and Repair
Fig. 9 Compressing lock plate
Disconnect battery ground cable.
Remove steering wheel as outlined under ``Horn Sounder & Steering Wheel, Replace'' procedure.
Using a screwdriver, pry cover from housing.
Using lock plate compressing tool J-23653, compress lock plate and pry retaining ring from groove on shaft, Fig. 9. Slowly release lock plate
compressing tool, remove tool and lock plate from shaft end.
Slide canceling cam and upper bearing preload spring from end of shaft.
Remove turn signal (multi-function) lever.
Remove hazard warning knob retaining screw, button, spring and knob.
Remove pivot arm.
Wrap upper part of electrical connector with tape to prevent snagging of wires during switch removal.
Remove switch retaining screws and pull switch up from column, guiding wire harness through column.
Reverse procedure to install.