S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
7.
Wipe entire wheel clean with the silicone remover and flush off again with water, followed by blow drying.
8.
Mask off areas of wheel not to be painted.
9.
Wipe over the painted surface with the aluminum cleaner; then apply the metal prep., following label directions. (This is a two-step operation
which will improve the adhesion of the primer.)
10.
To ensure coverage in all areas, an application of zinc chromate primer should be applied to the wheel painted surface in four (4) light
applications, rotating the wheel 90~ between applications.
11.
Apply the color coat using the same procedure as for the primer.
12.
After ten (10) minutes of air drying, heat may be applied to the paint to reduce drying time.
13.
When the wheel is completely dry, remove masking tape. Wheel must be perfectly clean of foreign material and dry before applying Coricone
1700, and clean the masked area with wax or silicone remover to eliminate tape residue.
14.
Spray two (2) light coatings of Coricone 1700 wheel protector on wheel allowing two (2) or three (3) minutes between coats. The clear coat will
put an invisible coating on top of the painted surface and the polished aluminum.
15.
DO NOT use heat on clear coat, allow to air dry for 24 hours.
16.
Reinstall the tire and wheel (re-align the index marks and/or the balance weight).
*For the nearest distributor in your area, call collect (416) 625-7900.
