S15/T15 Jimmy 2WD L4-119 1.9L VIN A 2-BBL (1983)
Air/Fuel Mixture: Adjustments
Federal
IDLE MIXTURE ADJUSTMENT
-
Set parking brake and block drive wheels.
-
Place transmission in neutral.
-
Remove carburetor assembly.
-
Remove idle mixture screw plug using a screw driver inserted into the slit on carburetor lower flange.
-
Reinstall carburetor assembly.
-
Make idle speed and mixture adjustment with the following conditions:
-
Engine at normal operating temperature.
-
Choke open.
-
A/C off.
-
Vacuum lines for distributor, idle compensator and EGR valve disconnected and plugged.
-
Idle compensator hose closed by bending hose.
-
Turn the idle mixture adjust screw all the way in and back out 1 1/2 turns.
-
Adjust throttle adjust screw to 850 rpm (M/T) or 950 rpm (A/T).
-
Adjust settion of idle mixture adjust screw to achieve the maximum speed.
-
Reset throttle adjust screw to above rpm.
-
Turn idle mixture adjust screw clockwise (lean) until engine speed is down to 800 rpm (M/T) or 900 rpm (A/T).
-
If A/C is installed:
-
Turn A/C on "Max COLD" and set blower to high.
-
Open the throttle to approximately 1/3 and allow the throttle to close. This allows the speed up solenoid to reach full travel.
-
Adjust the speed up controller adjusting screw to set idle at 900 rpm.
