S15/T15 Jimmy 4WD V6-262 4.3L VIN Z (1994)
Oxygen Sensor: Customer Interest
O2 Sensor - Rattling Noise/A/T Starts In 3rd Gear
FILE IN SECTION: 6E - Engine Fuel & Emission
BULLETIN NO.: 56-65-01
DATE: July, 1995
SUBJECT:
Rattling Noise on Acceleration/Transmission Starting Out in 3rd Gear (Provide Clearance or Replace Exhaust Crossover)
MODELS:
1993-94
Chevrolet and GMC Truck M/L Vans
1994
Chevrolet and GMC Truck T Models
1994
Oldsmobile Bravada
with 4.3L Engines (VINs W, Z - RPOs L35, LB4)
CONDITION
Customers may comment on one or more of the following conditions: A rattling noise on acceleration, transmission starting out in 3rd gear (possible
DTC 66, 67, 81, 82) and/or diagnostic trouble codes 13 or 44.
CAUSE
M/L Vans
Oxygen sensor and/or harness pigtail contacting the heat shield due to improper routing of the harness. Sharp edges of the heat shield cuts through the
wire insulation.
T Trucks
The rattle noise may be the oxygen sensor and/or harness pigtail contacting the heat shield due to the mispositioning of the oxygen sensor mounting boss.
Starting out in 3rd gear may be due to the pink wire (CKT 39) shorting out against the heat shield causing power to be interrupted to the transmission
control circuit putting the transmission into backup mode (3rd Gear Starts). Diagnostic trouble codes 13 or 44 may be set due to the oxygen sensor signal
wire shorting to or cut through by the heat shield.
CORRECTION
M/L Vans
Refer to the "1993 M/L Van Electrical Diagrams and Diagnosis" manual or the "1994 Driveability, Emissions and Electrical Diagnosis" manual for
circuit 39 schematics. Normal circuit diagnostics should be performed first if the problem is constant. If the problem is intermittent, an inspection of
circuit 39 (pink/black) in the area of the exhaust heat shields may lead to the problem. Inspect the oxygen sensor wiring and replace the sensor it the
insulation has been damaged. Re-route wiring harness as needed to protect harness. Clear any codes and test drive.
T Trucks
If the oxygen sensor is contacting the heat shield, this condition can be corrected by replacing the exhaust crossover pipe. If the oxygen sensor wire is
damaged, the oxygen sensor must also be replaced.
Follow regular Service Manual Procedures in Section 3 of the 1993 or 1994 "S/T Truck Driveability, Emission and Electrical Diagnosis" manual to
make above repairs. Clear any diagnostic trouble codes and test drive.
PARTS INFORMATION
P/N
Description
Qty
10096129
Sensor, Oxygen (1993)
1
25133503
Sensor, Oxygen (1994)
1
15661132
Pipe, Exhaust Crossover (w/ZR2)
1
15672887
Pipe, Exhaust Crossover (w/o ZR2)
1
Parts are currently available from GMSPO.
WARRANTY INFORMATION