S15/T15 Jimmy 4WD V6-262 4.3L VIN Z (1994)
Removing Bearing Retaining Bushing And Bearing Assembly
NOTICE: Use bearing retaining bushing (24) to aid in seating bearing assembly into housing assembly (16). Tab on bushing (24) must be fully
seated into slot in housing assembly (16).
A. Bearing assembly (25).
B. Bearing retaining bushing (24).
C. Switch actuator pivot assembly (31) with switch actuator pivot pin (30).
TIGHTEN
^
Tighten pin (30) to 3.1 Nm (27 lb.in.).
D. Rack preload spring (19).
E. Switch actuator sector (17).
ASSEMBLE
^
Spring thrust washer (22) to spring & bolt assembly (26).
^
Spring & bolt assembly (26) to switch actuator rack (20).
F. Spring & bolt assembly (26) with switch actuator rack (20) to housing assembly (16).
Installing Switch Actuator Rack To Sector
NOTICE: First tooth of rack (20) must interact with first and second tooth of sector (17). With rack (20) fully inserted, block tooth of sector (17)
will rest in block tooth of rack (20).
G. Key release spring (29).
H. Key release lever (28).
I.
Wave washer (27).
INSTALL OR CONNECT