S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Cowl Moulding / Trim: Service and Repair
Air Inlet Grille Panel Replacement
Removal Procedure
1. Raise and support the hood.
2. Remove the bolt from the right and the left vent grille end panels.
3. Lift up on the right and the left vent grille end panels to release the retaining clips.
4. Remove the right and the left vent grille end panels.
5. Remove the screws that secure the center vent grille panel to the cowl.
6. Remove the push-pin retainers that secure the center vent grille panel to the cowl.
7. Remove the center vent grille panel from the cowl.
Installation Procedure