S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
7. Install the water deflector.
8. Install the door trim panel.
Power Accessory Switch Panel
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the power accessory switch mounting cover from the door.
Use a flat-bladed tool in order to carefully pry the cover up at the front leading edge.
3. Disconnect the electrical connectors from the switches, if equipped.
4. Remove the switches from the switch mounting panel, if equipped.
Installation Procedure
1. Install the switches to the switch mounting panel, if equipped.
2. Connect the electrical connectors to the switches, if equipped.
3. Install the power accessory switch mounting cover to the door.
4. Position the cover and snap the cover into place.
5. Connect the negative battery cable.
Power Accessory Switch Panel Replacement
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the power accessory switch mounting cover from the door.