S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
Brake Hose/Line: Service and Repair
Front Brake Hose Replacement (RWD)
REMOVAL PROCEDURE
1. Clean the hose fittings at both ends. Remove all dirt, grease, and other foreign material.
2. Disconnect the brake pipe fitting.
3. Remove the brake hose retainer.
4. Remove the nut and bolt, if required.
5. Remove the bolt and the gaskets.
6. Remove the brake hose.
INSTALLATION PROCEDURE
IMPORTANT: After installation, the brake hose must not be twisted, and the brake hose must not come in contact with other components.
1. Install the brake hose. Ensure the hose is not twisted.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install new brass gaskets.
3. Install the bolt.