S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
5. Place the J 33023-A on the clutch rotor.
6. Install the J 41552 down into the inner circle of slots in the rotor.
Turn the J 41552 clockwise in the slots to engage the puller tangs with the rotor.
7. Hold the J 41552 in place and use a wrench to turn the center forcing screw against the J 33023-A to remove the clutch rotor and bearing
assembly.
Installation Procedure
Tools Required
-
J 33013-B Hub and Drive Plate Remover/Installer
-
J 33017 Pulley and Bearing Assembly Installer
1. Position the clutch rotor and bearing assembly (2) onto the compressor.
2. Position the J 33017and bearing (1) from the J 33013-B directly over the inner race of the bearing.