S15/T15 Sonoma P/U 2WD V6-4.3L VIN X (1998)
1. Using J 33169 for installation alignment, position the pressure plate and cover plate to the flywheel.
2. Secure the plates to the flywheel with bolts and washers.
-
Use the marks made during removal to align the plates if using the old clutch assembly.
-
Tighten each bolt one turn at a time in order to avoid warping the clutch pressure plate cover. Use a criss-cross pattern for tightening the bolts.
-
Tighten the pressure and cover plate bolts for the NV1500 transmission to 45 Nm (33 ft. lbs.).
-
Tighten the pressure and cover plate bolts for the NV3500 to 40 Nm (29 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Remove J 33169 from the clutch plates.
4. Install the transmission.
5. Lower the vehicle.
6. Test the transmission and clutch system for proper operation.