S15/T15 Sonoma P/U 4WD V6-4.3L VIN X (1998)
18. Place the top half of the J 41048 on the bottom half.
19. Check to make sure there are no pinch points on the boot before proceeding with procedures.
20. Insert the bolts (2). Tighten the bolts (2) by hand until snug.
21. Align the following items:
-
The boot
-
The housing
-
The swage clamp Tighten Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
NOTICE: Refer to Fastener Notice in Service Precautions.
22. Loosen the bolts.
23. Separate the dies.
24. Check the swage clamp for any "lip" deformities. If the deformities exist, place the swage clamp back into the J 41048.
25. Place the retaining snap ring into the CV joint inner race.
IMPORTANT: Ensure that the retaining ring side of the CV joint inner race faces the halfshaft bar (1) before installation.
26. Slide the CV joint (2) onto the halfshaft bar (1).
IMPORTANT: The retaining snap ring inside of the inner race engages in the halfshaft bar groove with a click when the CV joint is in the proper
position.
27. Pull on the CV joint (2) to verify engagement.
