Safari Van AWD V6-4.3L VIN W (1996)
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL PROCEDURE
Other than checking for loose hoses and electrical connectors, the only service possible is a unit replacement if the diagnosis shows a faulty MAP sensor.
IMPORTANT: After removing the MAP sensor from the intake manifold, replace the MAP sensor to intake manifold seal.
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in General Information.
2. Remove the electrical connector releasing the locking tab.
3. Remove the MAP sensor.
INSTALLATION PROCEDURE
1. Install the MAP sensor.
2. Install the electrical connector.
3. Connect the negative battery cable.