Safari Van M V6-262 4.3L (1985)
PROCEDURE FOR RELOCATING WIRES
3.
Install a new rear A/C motor P/N 22020945 using procedures on Page 1B-35 (86 manual). After installing the motor, the three (3) wire connector
on the rear A/C blower motor resistor should be checked for location of the wires in the connector. The wires should be in the positions shown in
Figure No. 2. If the wires are in an incorrect position, the yellow and orange wires will have to be switched using procedures in Figure No. 2. An
incorrectly positioned wire will result in no blower speed change when changing from low to medium.
4.
Check the seal between the side outlet duct and the blower motor housing, Figure 44, Page 1B- 37 and correct if necessary to assure a good seal.
The front A/C outlet seals should also be checked and baffles modified using the procedure previously described in the C60 Section, No. 7.
5.
Remove the rear upper outlet duct from the roof using procedures on Page 1B-36 (86 manual).
The roof A/C duct uses the rear section of the headliner as a seal. If the duct does not seal tightly to the headliner, air will leak between the parts. If
it becomes necessary to install a seal, foam tape should be used.
The rear edge of the headliner must also be sealed to the body to prevent air from escaping out of the duct and over the headliner. This can be done
by sealing the headliner to the body using foam tape.
6.
A hot water shut off valve may also be installed using procedures previously described in the C60 Section, No. 8.
