Safari Van M V6-262 4.3L (1985)
Control Arm Bushing: Service and Repair
Upper Control Arm Bushing
Fig. 2 Upper Control Arm Bushing Removal
Fig. 3 Upper Control Arm Bushing Installation
1.
Remove upper control arm as previously described.
2.
Remove nuts from end of pivot shaft, then press bushings out of control arm, Fig. 4.
3.
Position pivot shaft in control arm and press new bushings into control arm and over pivot shaft, Fig. 5. Both bushings must be installed
.48---.52 inch from face of control arm to bushing outer sleeve.
4.
Install pivot shaft retaining nuts and torque to 85 ft. lbs.