Safari Van M V6-262 4.3L VIN Z TBI (1990)
Glove Compartment: All Technical Service Bulletins
Glove Box - Rattle
GMC NUMBER:
90-10-28
GROUP:
10 Body Section
DATE:
January, 1990
CORPORATE
NUMBER:
961009
SUBJECT:
INSTRUMENT PANEL GLOVE BOX RATTLE
MODELS:
1990 M/L VANS
Some of the subject vans may experience a rattle from the instrument panel glove box area. A rattle can occur if the instrument panel lower extension is
loose. To verify, hold the cup holder on the instrument panel lower extension and try to move it fore and aft. If the extension moves, the rattle is likely to
be coming from this area. To correct, it is necessary to install foam adhesive backed strips to the back side of the instrument panel lower extension.
Figure 1
INSTALLATION INSTRUCTIONS:
(Refer to Fig. 1)
Remove the instrument panel lower extension.
Install three (3) foam adhesive backed strips (one strip at each end and one in the center) on
the back top side of the extension in the area contacting the lower curl of the metal retainer located on the instrument panel.
The strips should be approximately 2-1/2" long, 1/4" thick and 1/2" wide.
PART INFORMATION:
Foam backed adhesive strips can be purchased locally in roll form and cut to length. This is not a service part at GMSPO.
