Savana 2500 V6-4.3L VIN X (2005)
Center Mounted Brake Lamp: Procedures
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the screws (3) that retain the center high mounted stop lamp lens.
2. Remove the center high mounted stop lamp lens (2).
3. Disconnect the bulb socket (1) from the center high mounted stop lamp.
4. Remove the bulb (1) from the socket.
INSTALLATION PROCEDURE
1. Install the bulb (1) into the socket.
2. Connect the bulb socket (1) into the center high mounted stop lamp lens.
3. Install the center high mounted stop lamp lens (2).
4. Install the center high mounted stop lamp lens retaining screws (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the center high mounted stop lamp lens screws to 1.5 N.m (13 lb in).
