Savana 2500 V8-6.6L DSL Turbo (2008)
Acceleration/Deceleration Sensor: Service and Repair
Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement
Removal Procedure
1. Remove the passenger seat from the vehicle. Refer to Seat Replacement .
2. Pull the carpet back to gain access to the sensor.
3. Remove the nuts (2) retaining the yaw rate sensor/lateral accelerometer (1) to the vehicle.
4. Disconnect the electrical connector (3) from the yaw rate sensor/lateral accelerometer.
5. Remove the yaw rate sensor/lateral accelerometer from the vehicle.
Installation Procedure
1. Install the yaw rate sensor/lateral accelerometer (1) to the vehicle.
Notice: Refer to Fastener Notice .
2. Install the nuts (2) retaining the yaw rate sensor/lateral accelerometer (1) to the vehicle.
Tighten the nuts to 10 N.m (89 lb in).
3. Perform the YAW rate reference table reset procedure. Refer to Yaw Rate Reference Table Resetting (See: Yaw Rate Sensor/Service and
Repair/Procedures) .
4. Connect the electrical connector (3) to the yaw rate sensor/lateral accelerometer (1).
5. Install the carpet.
6. Install the passenger seat to the vehicle. Refer to Seat Replacement .
