Savana 2500 V8-6.6L DSL Turbo (2008)
6. Vehicles Built After June 2004:
1. Remove the front and rear power steering bracket bolts from the A/C compressor/power steering pump bracket. Refer to graphic illustration
numbers 4, 2, and 1.
2. Reposition the power steering pump to gain access to drill larger holes into the rear mounting bracket using a 14 mm (1/2 in) drill bit. Drilling
the bolt holes larger will ensure proper alignment of the bracket when installing the bolts. Refer to graphic illustration number 2.
3. Install the power steering pump to A/C compressor/power steering pump bracket. Refer to graphic illustration numbers 4, 2, and 1.
Important
Power steering pump front mounting bolts must always be tightened first to ensure correct pulley alignment.
4. Refer to graphic illustration number 4 and tighten the front power steering pump mounting bolts.
Tighten
Tighten the bolts to 50 Nm (37 lb ft).
5. Refer to graphic illustration number 2 and tighten the rear bracket bolts.
Tighten
Tighten the bolts to 50 Nm (37 lb ft).
Dual Generator System
New belts are not available for dual generator systems. If a belt chirp noise is occurring on a dual generator system, please complete a Field Product
Report (FPR). The instructions for completing a FPR can be found in Service Bulletin Number 02-00-89-002G.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.