Savana 2500 V8-6.6L DSL Turbo (2008)
Fuel Injector: Service and Repair
Fuel Injector Replacement (Left)
Fuel Injector Replacement (Left)
Special Tools
*
EN-47909 Injector Bore and Sleeve Cleaning Kit
*
J-46594 Fuel Injector Puller
Removal Procedure
1. Remove the upper fan shroud.
2. If equipped, remove the auxiliary generator.
3. Remove the glow plug module and bracket.
4. Remove the injector/glow plug wire harness retaining bolt at lower upper valve cover.
5. Disconnect the left engine wiring harness connector.
6. Remove the engine wiring harness to bracket bolt, the 2 engine wiring harness bracket to upper valve cover bolts and remove the bracket (1).
Important:
*
Prior to removal of the fuel injector pipes, use compressed air to remove any debris from the injector line and fittings.