Savana 2500 V8-6.6L DSL Turbo (2008)
9. Remove the 2-4 servo assembly from the transmission.
10. Inspect the 4th apply piston, the 2-4 servo converter, 2nd apply piston, and the piston inner housing for the following defects:
*
Cracks
*
Scoring
*
Burrs and nicks
Installation Procedure
1. Install the new seals on the pistons and the servo cover.
2. Lubricate the seals with clean transmission fluid.
3. Install the 2-4 servo assembly into the 2-4 servo bore.
4. Install the servo cover and O-ring seal.
5. Install the J 29714-A .
6. Tighten the bolt on the J 29714-A in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A from the oil pan flange.
Notice: Refer to Fastener Notice .
9. Install the oil pan bolt.
Tighten the oil pan bolt to 11 N.m (97 lb in).
10. Install the 2 heat shield retaining bolts and the heat shield from the transmission.