Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Rear Brake Caliper Bracket Replacement (15/25 Series)
Rear Brake Caliper Bracket Replacement (15/25 Series)
Caution: Refer to Brake Dust Caution.
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
3. Remove the brake caliper from the brake caliper mounting bracket and support the brake caliper with heavy mechanic's wire or equivalent. DO
NOT disconnect the hydraulic brake hose from the brake caliper.
4. Remove the brake pads from the brake caliper mounting bracket.
5. Remove the anti-rattle clips from the brake caliper bracket.
6. Remove the brake caliper bracket mounting bolts (2).
7. Remove the brake caliper bracket (1).
8. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
9. Clean the mounting surface and threads of the brake caliper bracket.
Installation Procedure
